Notifications
Clear all
ekmek
Grupa: Zarejestrowany
Dołączył: 2020/10/03
Active Member
1
Any word if PrusaSlicer will support Elegoo Mars? In forum PrusaSlicer |
4 years temu | |
Thanks, it could be because I did do a higher temp to get th... In forum Hardware, firmware and software help |
4 years temu | |
I'm having the same problem. Any way to prevent this? In forum Hardware, firmware and software help |
4 years temu | |
Did this get resolved? I have the same problem with OBJ impo... In forum PrusaSlicer |
4 years temu | |
I noticed this too. But since my PLA wouldn't stick I turne... In forum PrusaSlicer |
4 years temu | |
@john-h68 When I type R or a number I get nothing. Is there ... In forum PrusaSlicer |
4 years temu | |
Well it worked for a bit. Then I ran into the issue again. ... | 4 years temu | |
Thanks guys this helped a lot. When I disassembled it I did... | 4 years temu | |
@daniel-s89 Thanks, let me block off some time and have a g... | 4 years temu | |
I had a similar problem. The calibration wasn't getting clos... | 4 years temu | |
I think I have a similar problem but I'm going to have to ta... | 4 years temu |