Prusa3D Forum

Notifications

Clear all

Egghebrecht

Grupa: Zarejestrowany

Dołączył: 2021/09/11

Active Member

	OK filament dried etc print is better BUT I noticed the fila... In forum Hardware, firmware and software help	3 years temu
	Tested the belt with the belt tension meter and it was what ... In forum Hardware, firmware and software help	3 years temu
	well the annoying thing about the filament is that it is PET... In forum Hardware, firmware and software help	3 years temu
	Damp filament is unlikely, but not impossible, even with the... In forum Hardware, firmware and software help	3 years temu
	Let's try those pictures again, they are in the original pos... In forum Hardware, firmware and software help	3 years temu
	X-axis Layer shift and bad bridging/dirty print In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

565 Fora

63.9 K Tematy

447.7 K Posty

19 Online

69.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte