Prusa3D Forum

Notifications

Clear all

Egghebrecht

Skupina: Registrovaný

Přidal se: 2021/09/11

Active Member

	OK filament dried etc print is better BUT I noticed the fila... In forum Hardware, firmware and software help	před 3 years
	Tested the belt with the belt tension meter and it was what ... In forum Hardware, firmware and software help	před 3 years
	well the annoying thing about the filament is that it is PET... In forum Hardware, firmware and software help	před 3 years
	Damp filament is unlikely, but not impossible, even with the... In forum Hardware, firmware and software help	před 3 years
	Let's try those pictures again, they are in the original pos... In forum Hardware, firmware and software help	před 3 years
	X-axis Layer shift and bad bridging/dirty print In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

559 Fóra

63 K Témata

443.3 K Příspěvky

20 Online

67.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed