Notifications
Clear all
EffectStyle
Skupina: Registrovaný
Přidal se: 2021/10/02
Active Member
1
|
tnx you a lot i`me bad on this thing i need to learn in some... In forum Hardware, firmware and software help |
před 3 years | |
|
Extrudor Motor Replacmant In forum Hardware, firmware and software help |
před 3 years | |
|
I`ts this from the Axis ore the extruder In forum Hardware, firmware and software help |
před 4 years | |
|
tnx i will try it 🙂 In forum Hardware, firmware and software help |
před 4 years | |
| the problems was in the X axis | před 4 years | |
|
Z Axis Problem In forum Hardware, firmware and software help |
před 4 years | |
| The only thing add it is ironing | před 4 years | |
| I have try whit Matt PLE this whit 0.6 nozel and 0.3 leyer | před 4 years | |
| i`ts PETG galaxy black | před 4 years | |
| Print Break on part | před 4 years | |
|
tnx for the help some left overs in the heatbreak In forum Hardware, firmware and software help |
před 4 years | |
|
I need Help In forum Hardware, firmware and software help |
před 4 years | |
| i have the same problem whit prusa galaxy black filament | před 4 years |