Prusa3D Forum

Notifications

Clear all

ed.y

Groupe: Enregistré

A(ont) rejoint: 2016/09/21

Eminent Member

	MK3 coming! Dans le forum Others (Archive)	il y a 7 years
	Trying right clicking on the Prusa Control icon then go to P... Dans le forum Software (Archive)	il y a 7 years
	Just be careful that you check the nozzle is not leaking int... Dans le forum Others (Archive)	il y a 7 years
	I've used Rigid.Ink PLA, have to say it doesn't seem to be a... Dans le forum Others (Archive)	il y a 7 years
	do yo have your nozzle fan on? I had this issue where I had ... Dans le forum Software (Archive)	il y a 7 years
	For some info in my enclosure my temps are: ABS Nozzle 250C,... Dans le forum Others (Archive)	il y a 7 years
	Humidity inside enclosure is only 15% when I start printing.... Dans le forum Others (Archive)	il y a 7 years
	For me I did a 12 hour print with ABS, nozzle temp 250C heat... Dans le forum Others (Archive)	il y a 7 years
	I agree with hendrik those screws are part of the motor asse... Dans le forum Others (Archive)	il y a 7 years
	Maximum working temperature? Dans le forum Others (Archive)	il y a 7 years
	I had this issue just last week. I did find the cause. I wa... Dans le forum Others (Archive)	il y a 7 years
	Hi just an update on this. I think it is a print speed issue... Dans le forum Print tips (Archive)	il y a 8 years
	ABS Issues Dans le forum Print tips (Archive)	il y a 8 years
	I've not noticed this Full RX Buffer error but I have seen: ... Dans le forum Others (Archive)	il y a 8 years
	I had this issue recently when I did a bit of a rebuild and ... Dans le forum Others (Archive)	il y a 8 years
	I had this issue over the weekend. I decide to solder the wi... Dans le forum Others (Archive)	il y a 8 years
	Melted heat bed connector Dans le forum Others (Archive)	il y a 8 years
	I have same issue also, doesn't seem to affect printing, but... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	an update on my issue. It looks like it is Ocoprint causing ... Dans le forum Others (Archive)	il y a 8 years
	I have this same problem. I've got the MK2. It seems to hap... Dans le forum Others (Archive)	il y a 8 years

Page 1 / 2 Suivant

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

21 En-ligne

68.1 K Membres

Le dernier des messages: First post! First issue too... 🙁 Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé