dtice – Activity – Prusa3D Forum

Notifications

Clear all

dtice

Group: Registered

Joined: 2023/06/09

Eminent Member

	Prusa suggested loosening the Trapezoidal nuts a little bit.... In forum Hardware, firmware and software help	1 year ago
	100% agree. I'm going to give them a call after I finish a ... In forum Hardware, firmware and software help	1 year ago
	This was purchased assembled. My guess is either a stepper... In forum Hardware, firmware and software help	1 year ago
	Here's the video. Mk4-Z-Axis-Fail2.mp4 In forum Hardware, firmware and software help	1 year ago
	Z-axis problem causing dent in bed In forum Hardware, firmware and software help	1 year ago
	Thanks to Diem my problem is no longer! I took the textured... In forum Assembly and first prints troubleshooting	1 year ago
	Thanks, I will give that a go. I think I'm going to also ma... In forum Assembly and first prints troubleshooting	1 year ago
	Petg first layer adhesion problem In forum Assembly and first prints troubleshooting	1 year ago
	Thanks again for the replies. I found the solution to be pr... In forum How do I print this? (Printing help)	1 year ago
	Thanks for all the replies. I didn't take photos. I was pr... In forum How do I print this? (Printing help)	1 year ago
	Printing Silk - Lifting issue In forum How do I print this? (Printing help)	1 year ago

Page 2 / 2 Prev

Forum Statistics

559 Forums

62.9 K Topics

442.9 K Posts

21 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed