Prusa3D Forum

Notifications

Clear all

dstarr3

Groupe: Enregistré

A(ont) rejoint: 2021/02/07

Active Member

	Right, yes. More specifically, the upgrade to the Mk4 is mor... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 2 years
	Preparing printer for ABS/nylon/etc? Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 2 years
	Can confirm, flashed prusa3d_fw_MK3S_MK3S+_3_10_1-RC1_4587.h... Dans le forum Hardware, firmware and software help	il y a 4 years
	Well, I've tried all these things. Compressed air to clean o... Dans le forum Hardware, firmware and software help	il y a 4 years
	I think the worst case scenarios here, while both being very... Dans le forum Hardware, firmware and software help	il y a 4 years
	Anybody? Dans le forum Hardware, firmware and software help	il y a 4 years
	FW update, SD card not being read properly, printer crashing Dans le forum Hardware, firmware and software help	il y a 4 years
	Appears to be the case. An update: It took about an hour and... Dans le forum Hardware, firmware and software help	il y a 5 years
	Prusa MK3S won't start, flickering LCD Dans le forum Hardware, firmware and software help	il y a 5 years

Statistiques du forum

585 Forums

68 K Sujets

476.3 K Messages

11 En-ligne

75.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé