Notifications
Clear all
dstarr3
Skupina: Registrovaný
Přidal se: 2021/02/07
Active Member
1
| Right, yes. More specifically, the upgrade to the Mk4 is mor... | před 2 years | |
| Preparing printer for ABS/nylon/etc? | před 2 years | |
|
Can confirm, flashed prusa3d_fw_MK3S_MK3S+_3_10_1-RC1_4587.h... In forum Hardware, firmware and software help |
před 4 years | |
|
Well, I've tried all these things. Compressed air to clean o... In forum Hardware, firmware and software help |
před 4 years | |
|
I think the worst case scenarios here, while both being very... In forum Hardware, firmware and software help |
před 4 years | |
|
Anybody? In forum Hardware, firmware and software help |
před 4 years | |
|
FW update, SD card not being read properly, printer crashing In forum Hardware, firmware and software help |
před 4 years | |
|
Appears to be the case. An update: It took about an hour and... In forum Hardware, firmware and software help |
před 5 years | |
|
Prusa MK3S won't start, flickering LCD In forum Hardware, firmware and software help |
před 5 years |