Notifications
Clear all
dstarr3
Group: Registered
Joined: 2021/02/07
Active Member
1
Right, yes. More specifically, the upgrade to the Mk4 is mor... | 10 months ago | |
Preparing printer for ABS/nylon/etc? | 10 months ago | |
Can confirm, flashed prusa3d_fw_MK3S_MK3S+_3_10_1-RC1_4587.h... In forum Hardware, firmware and software help |
3 years ago | |
Well, I've tried all these things. Compressed air to clean o... In forum Hardware, firmware and software help |
3 years ago | |
I think the worst case scenarios here, while both being very... In forum Hardware, firmware and software help |
3 years ago | |
Anybody? In forum Hardware, firmware and software help |
3 years ago | |
FW update, SD card not being read properly, printer crashing In forum Hardware, firmware and software help |
3 years ago | |
Appears to be the case. An update: It took about an hour and... In forum Hardware, firmware and software help |
4 years ago | |
Prusa MK3S won't start, flickering LCD In forum Hardware, firmware and software help |
4 years ago |