Prusa3D Forum

Notifiche

Cancella tutti

DrHotwing

Gruppo: Registrato

Registrato: 2021/03/23

Active Member

	@3delight Will do! Nel forum Hardware, firmware and software help	4 years fa
	Thank you all for your help in this matter. I ended up conta... Nel forum Hardware, firmware and software help	4 years fa
	OK, so I heated to 220c, once at 220c I placed a meat thermo... Nel forum Hardware, firmware and software help	4 years fa
	@hli Yes, I tried taking the nozzle out and the P.I.N.D.A se... Nel forum Hardware, firmware and software help	4 years fa
	1) Reflashing the firmware for the MK3? - Yes. Reflashed it ... Nel forum Hardware, firmware and software help	4 years fa
	@karl-herbert I've done each item (and many more) and nothin... Nel forum Hardware, firmware and software help	4 years fa
	@clarmrrsn OK I ran the PID calibration. Tried the first lay... Nel forum Hardware, firmware and software help	4 years fa
	@clarmrrsn No, not yet Nel forum Hardware, firmware and software help	4 years fa
	@clarmrrsn I replaced my E3D V6 hotend with the exact same. ... Nel forum Hardware, firmware and software help	4 years fa
	Hot End Problems Nel forum Hardware, firmware and software help	4 years fa

Statistiche Forum

559 Forum

63 K Discussioni

443.7 K Post

21 Online

67.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso