Prusa3D Forum

Notifications

Clear all

Dracx

Groupe: Enregistré

A(ont) rejoint: 2016/11/28

Active Member

	Experiencing the same Dans le forum Bugs & Errors	il y a 8 months
	I the process of testing, I found that I was having a simila... Dans le forum Others (Archive)	il y a 7 years
	I use S3D with no errors, but I'm still tweaking to get resu... Dans le forum Others (Archive)	il y a 7 years
	I'm having the same trouble. The sensor was working fine ri... Dans le forum Others (Archive)	il y a 7 years
	I wouldn't worry about it. I expect most of the issues to b... Dans le forum Others (Archive)	il y a 7 years
	All prints offset by Y + 11mm Dans le forum Others (Archive)	il y a 7 years
	I used blue thread locker on my MK2S kit with no issues for ... Dans le forum Others (Archive)	il y a 7 years
	I'm running b137 and woke up to the printer (left on overnig... Dans le forum Hardware, firmware and software help	il y a 7 years
	I'm running my MK2S and new MK3 (Merry Christmas to me!) rig... Dans le forum Others (Archive)	il y a 7 years
	Same issue here. I also had to use the same zip-tie fix (u... Dans le forum Others (Archive)	il y a 7 years
	I'm running my MK2S and new MK3 (Merry Christmas to me!) rig... Dans le forum Others (Archive)	il y a 7 years
	I'll throw my hat in with the positive experience. I bought... Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.1 K Messages

20 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé