|
Support blockers not working In forum PrusaSlicer |
4 years ago |
|
That's great news thanks David, so I can leave the MMU2 firm... In forum Hardware, firmware and software help |
5 years ago |
|
Thanks David. I just unplugged it and flashed the other firm... In forum Hardware, firmware and software help |
5 years ago |
|
Downgrading from MMU2S to MK3S In forum Hardware, firmware and software help |
5 years ago |
|
If there’s a cutter in the MMU, it opens the possibility of ... In forum General discussion, announcements and releases |
7 years ago |
|
Eliminating PINDA Probe In forum Others (Archive) |
7 years ago |
|
Thanks--I'll be sure to bond their grounds if I do use two P... In forum Hardware, firmware and software help |
7 years ago |
|
I'd like to use a second PSU just for the heatbed to elimina... In forum Hardware, firmware and software help |
7 years ago |
|
Any luck with this?
I might try cranking up the temperature... In forum Others (Archive) |
7 years ago |
|
I had the same issue and it appears to be fixed by dialing m... In forum Others (Archive) |
7 years ago |
|
Filament Sensor Tripping Falsely on Shiny PETG In forum Others (Archive) |
7 years ago |
|
I think alexander.t2 means the trap nut ;).
Anyway with my... In forum Others (Archive) |
7 years ago |
|
The rocking motion is purely a consequence of the rubbing.
... In forum Others (Archive) |
7 years ago |
|
Well I found my issue. I misassembled my extruder by mountin... In forum Others (Archive) |
7 years ago |
|
Same exact issue here (x axis belt rubs on front/lower-y fla... In forum Others (Archive) |
7 years ago |
|
Ran into this problem just now, I fixed it by jogging the Z ... In forum Others (Archive) |
7 years ago |
|
Same problem here with my new MK3 kit, latest firmware.
Same... In forum Others (Archive) |
7 years ago |
