|
Support blockers not working Nel forum PrusaSlicer |
4 years fa |
|
That's great news thanks David, so I can leave the MMU2 firm... Nel forum Hardware, firmware and software help |
5 years fa |
|
Thanks David. I just unplugged it and flashed the other firm... Nel forum Hardware, firmware and software help |
5 years fa |
|
Downgrading from MMU2S to MK3S Nel forum Hardware, firmware and software help |
5 years fa |
|
If there’s a cutter in the MMU, it opens the possibility of ... Nel forum General discussion, announcements and releases |
7 years fa |
|
Eliminating PINDA Probe Nel forum Others (Archive) |
7 years fa |
|
Thanks--I'll be sure to bond their grounds if I do use two P... Nel forum Hardware, firmware and software help |
7 years fa |
|
I'd like to use a second PSU just for the heatbed to elimina... Nel forum Hardware, firmware and software help |
7 years fa |
|
Any luck with this?
I might try cranking up the temperature... Nel forum Others (Archive) |
7 years fa |
|
I had the same issue and it appears to be fixed by dialing m... Nel forum Others (Archive) |
7 years fa |
|
Filament Sensor Tripping Falsely on Shiny PETG Nel forum Others (Archive) |
7 years fa |
|
I think alexander.t2 means the trap nut ;).
Anyway with my... Nel forum Others (Archive) |
7 years fa |
|
The rocking motion is purely a consequence of the rubbing.
... Nel forum Others (Archive) |
7 years fa |
|
Well I found my issue. I misassembled my extruder by mountin... Nel forum Others (Archive) |
7 years fa |
|
Same exact issue here (x axis belt rubs on front/lower-y fla... Nel forum Others (Archive) |
7 years fa |
|
Ran into this problem just now, I fixed it by jogging the Z ... Nel forum Others (Archive) |
7 years fa |
|
Same problem here with my new MK3 kit, latest firmware.
Same... Nel forum Others (Archive) |
7 years fa |
