Notifications
Clear all
dingfelder
Skupina: Registrovaný
Přidal se: 2022/07/25
Active Member
1
| yes its a strange mix. what I got I think was the upgrade k... | před 2 years | |
| I believe you are correct that the motors may be clones | před 2 years | |
| you are right. i disconnected the filament sensor as I was ... | před 2 years | |
| You may be right - this is what my steel sheet looks like ... | před 2 years | |
|
The extruder is stock MK3S Some parts on the axis are upgrad... In forum Hardware, firmware and software help |
před 2 years | |
| I have: MK3plus a MK3S upgrade kit,plus MMU2 option (not yet... | před 2 years | |
| What is this | před 2 years | |
|
the Mk3s and later versions have an Infrared filament sensor... In forum Hardware, firmware and software help |
před 2 years | |
|
ok, I got impatient and upgraded my firmware - hopefully thi... In forum Hardware, firmware and software help |
před 2 years | |
|
following up on this - ive just gotten from settings main bo... In forum Hardware, firmware and software help |
před 2 years | |
|
sensor and board version compatability In forum Hardware, firmware and software help |
před 2 years |