Notifiche
Cancella tutti
dennis.s
Gruppo: Registrato
Registrato: 2015/06/28
Active Member
1
Hi Peter,
I have a few questions if you don't mind answerin... Nel forum Software (Archive) |
9 years fa | |
Not sure if this helps, but I had an issue with the heat bed... Nel forum Prusa i3 kit (Archive) |
9 years fa | |
Thanks for the reply! You're right, it was the gcode but I h... Nel forum Prusa i3 kit (Archive) |
9 years fa | |
Thanks Peter. I understand that. I have lowered the speed of... Nel forum Prusa i3 kit (Archive) |
9 years fa | |
Print checking End Stops in the middle of print Nel forum Prusa i3 kit (Archive) |
9 years fa | |
Printer Problem: New Slic3r Settings are too fast for 3mm ho... Nel forum Prusa i3 kit (Archive) |
9 years fa | |
Print Bed Glass Question Nel forum Prusa i3 kit (Archive) |
9 years fa |