Notifications
Clear all
dennis.s
Groupe: Enregistré
A(ont) rejoint: 2015/06/28
Active Member
1
|
Hi Peter,
I have a few questions if you don't mind answerin... Dans le forum Software (Archive) |
il y a 9 years | |
|
Not sure if this helps, but I had an issue with the heat bed... Dans le forum Prusa i3 kit (Archive) |
il y a 9 years | |
|
Thanks for the reply! You're right, it was the gcode but I h... Dans le forum Prusa i3 kit (Archive) |
il y a 9 years | |
|
Thanks Peter. I understand that. I have lowered the speed of... Dans le forum Prusa i3 kit (Archive) |
il y a 9 years | |
|
Print checking End Stops in the middle of print Dans le forum Prusa i3 kit (Archive) |
il y a 9 years | |
|
Printer Problem: New Slic3r Settings are too fast for 3mm ho... Dans le forum Prusa i3 kit (Archive) |
il y a 9 years | |
|
Print Bed Glass Question Dans le forum Prusa i3 kit (Archive) |
il y a 9 years |