Notifications
Clear all
dennis.s
Group: Registered
Joined: 2015/06/28
Active Member
1
|
Hi Peter,
I have a few questions if you don't mind answerin... In forum Software (Archive) |
9 years ago | |
|
Not sure if this helps, but I had an issue with the heat bed... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Thanks for the reply! You're right, it was the gcode but I h... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Thanks Peter. I understand that. I have lowered the speed of... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Print checking End Stops in the middle of print In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Printer Problem: New Slic3r Settings are too fast for 3mm ho... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Print Bed Glass Question In forum Prusa i3 kit (Archive) |
10 years ago |