Notifications
Clear all
ddd
Skupina: Registrovaný
Přidal se: 2016/11/22
New Member
|
Did you tighten the two extruder screw enough? if not, the l... In forum Others (Archive) |
před 7 years | |
|
Wow, this topic is so important it should be on the top lis... In forum Prusa i3 kit (Archive) |
před 7 years | |
|
I have the same problem here.
Apparently the extuder pulley ... In forum Others (Archive) |
před 7 years | |
|
You can try updating to the latest firmware:
I did it and ... In forum Prusa i3 kit (Archive) |
před 7 years |