|
Beyond my understanding:Suddenly, 2.9.2 began to fail connec... En el foro PrusaSlicer |
hace 7 months |
|
The OS settings already allow PrusaSlicer to caccess the LAN... En el foro PrusaSlicer |
hace 7 months |
|
:80 did not work. It's running on top of Debian at the mome... En el foro PrusaSlicer |
hace 7 months |
|
I have. No change. En el foro PrusaSlicer |
hace 7 months |
|
192.168.1.127:5000 En el foro PrusaSlicer |
hace 7 months |
|
It is still set to Octoprint. En el foro PrusaSlicer |
hace 7 months |
|
I have, but it's not very helpful. 2.9.3 has this line: [202... En el foro PrusaSlicer |
hace 7 months |
|
Yes. I can ping. I can access OctoPrint via the browser. I c... En el foro PrusaSlicer |
hace 7 months |
|
MacOS. I can give that a try, but I don't hold out hope. En el foro PrusaSlicer |
hace 7 months |
|
The same error I posted above. En el foro PrusaSlicer |
hace 7 months |
|
Tried both, config looks fine (as you'd expect since 2.9.2 ... En el foro PrusaSlicer |
hace 7 months |
|
I too am having this problem. 2.9.3 is failing with Could no... En el foro PrusaSlicer |
hace 7 months |
|
Problem went away with a firmware upgrade (which naturally w... En el foro Hardware, firmware and software help |
hace 11 months |
|
It turns out, no. I reformatted with a linux system and it w... En el foro Hardware, firmware and software help |
hace 11 months |
|
P.S. The time seems fine, so I doubt that's it. Does it go... En el foro Hardware, firmware and software help |
hace 11 months |
|
TLS Failure En el foro Hardware, firmware and software help |
hace 11 months |
|
"MS-DOS (FAT)" is apparently FAT32 on MacOS. My printer is ... En el foro Hardware, firmware and software help |
hace 11 months |
|
Firmware upgrade not happening En el foro Hardware, firmware and software help |
hace 11 months |
|
Pause for filament chanage behavior En el foro PrusaSlicer |
hace 1 year |
|
Turns out that fix is the one I need. En el foro PrusaSlicer |
hace 1 year |
