|
Beyond my understanding:Suddenly, 2.9.2 began to fail connec... Im Forum PrusaSlicer |
Vor 6 months |
|
The OS settings already allow PrusaSlicer to caccess the LAN... Im Forum PrusaSlicer |
Vor 7 months |
|
:80 did not work. It's running on top of Debian at the mome... Im Forum PrusaSlicer |
Vor 7 months |
|
I have. No change. Im Forum PrusaSlicer |
Vor 7 months |
|
192.168.1.127:5000 Im Forum PrusaSlicer |
Vor 7 months |
|
It is still set to Octoprint. Im Forum PrusaSlicer |
Vor 7 months |
|
I have, but it's not very helpful. 2.9.3 has this line: [202... Im Forum PrusaSlicer |
Vor 7 months |
|
Yes. I can ping. I can access OctoPrint via the browser. I c... Im Forum PrusaSlicer |
Vor 7 months |
|
MacOS. I can give that a try, but I don't hold out hope. Im Forum PrusaSlicer |
Vor 7 months |
|
The same error I posted above. Im Forum PrusaSlicer |
Vor 7 months |
|
Tried both, config looks fine (as you'd expect since 2.9.2 ... Im Forum PrusaSlicer |
Vor 7 months |
|
I too am having this problem. 2.9.3 is failing with Could no... Im Forum PrusaSlicer |
Vor 7 months |
|
Problem went away with a firmware upgrade (which naturally w... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
It turns out, no. I reformatted with a linux system and it w... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
P.S. The time seems fine, so I doubt that's it. Does it go... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
TLS Failure Im Forum Hardware, firmware and software help |
Vor 11 months |
|
"MS-DOS (FAT)" is apparently FAT32 on MacOS. My printer is ... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Firmware upgrade not happening Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Pause for filament chanage behavior Im Forum PrusaSlicer |
Vor 1 year |
|
Turns out that fix is the one I need. Im Forum PrusaSlicer |
Vor 1 year |
