Notifications
Clear all
dawid.k
Group: Registered
Joined: 2017/02/26
Active Member
1
I shit you not guys. It was the PINDA. 😡 I adjusted it a b... In forum Prusa i3 kit (Archive) |
8 years ago | |
Menu -> Calibration -> Self-test In forum Prusa i3 kit (Archive) |
8 years ago | |
As I said before, I updated the firmware to this:
I did cal... In forum Prusa i3 kit (Archive) |
8 years ago | |
First try was quite a fail 😀
This guide is way better t... In forum Prusa i3 kit (Archive) |
8 years ago | |
Bed level correction 50 µm is not enough In forum Prusa i3 kit (Archive) |
8 years ago | |
Thanks. I will check this. | 8 years ago | |
.... How can I adjust the table to be level?... there are 4 ... | 8 years ago | |
In your printer: Calibration -> bed level correction | 8 years ago | |
I did many calibration prints and always had same issue. The... | 8 years ago |