Notifications
Clear all
dawid.k
Skupina: Registrovaný
Přidal se: 2017/02/26
Active Member
1
|
I shit you not guys. It was the PINDA. 😡 I adjusted it a b... In forum Prusa i3 kit (Archive) |
před 9 years | |
|
Menu -> Calibration -> Self-test In forum Prusa i3 kit (Archive) |
před 9 years | |
|
As I said before, I updated the firmware to this:
I did cal... In forum Prusa i3 kit (Archive) |
před 9 years | |
|
First try was quite a fail 😀
This guide is way better t... In forum Prusa i3 kit (Archive) |
před 9 years | |
|
Bed level correction 50 µm is not enough In forum Prusa i3 kit (Archive) |
před 9 years | |
| Thanks. I will check this. | před 9 years | |
| .... How can I adjust the table to be level?... there are 4 ... | před 9 years | |
| In your printer: Calibration -> bed level correction | před 9 years | |
| I did many calibration prints and always had same issue. The... | před 9 years |