Notifications
Clear all
dawid.k
Group: Registered
Joined: 2017/02/26
Active Member
1
|
I shit you not guys. It was the PINDA. 😡 I adjusted it a b... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Menu -> Calibration -> Self-test In forum Prusa i3 kit (Archive) |
9 years ago | |
|
As I said before, I updated the firmware to this:
I did cal... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
First try was quite a fail 😀
This guide is way better t... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Bed level correction 50 µm is not enough In forum Prusa i3 kit (Archive) |
9 years ago | |
| Thanks. I will check this. | 9 years ago | |
| .... How can I adjust the table to be level?... there are 4 ... | 9 years ago | |
| In your printer: Calibration -> bed level correction | 9 years ago | |
| I did many calibration prints and always had same issue. The... | 9 years ago |