Notifications
Clear all
davidwest
Groupe: Enregistré
A(ont) rejoint: 2021/03/21
New Member
|
I have found that I get the best results when I copy the Pru... Dans le forum PrusaSlicer |
il y a 3 years | |
|
I had the same problem and found a solution. I pulled out th... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
After completing the wizard and getting more into Prusa Slic... Dans le forum PrusaSlicer |
il y a 5 years | |
|
Using a filament not listed in Prusa Slicer (Mika 3D from Am... Dans le forum PrusaSlicer |
il y a 5 years |