Notifications
Clear all
davidwest
Skupina: Registrovaný
Přidal se: 2021/03/21
New Member
|
I have found that I get the best results when I copy the Pru... In forum PrusaSlicer |
před 3 years | |
|
I had the same problem and found a solution. I pulled out th... In forum Hardware, firmware and software help |
před 3 years | |
|
After completing the wizard and getting more into Prusa Slic... In forum PrusaSlicer |
před 4 years | |
|
Using a filament not listed in Prusa Slicer (Mika 3D from Am... In forum PrusaSlicer |
před 4 years |