Prusa3D Forum

Notifications

Clear all

David Stephenson

Groupe: Enregistré

A(ont) rejoint: 2023/01/24

Active Member

	And the coupler is stripped yay, this is a fun project, no i... Dans le forum Assembly and first prints troubleshooting	il y a 1 month
	Overextruding at start of print Dans le forum Hardware, firmware and software help	il y a 1 year
	Thanks for all the advice everyone, it turned out ribbon cab... Dans le forum Assembly and troubleshooting	il y a 2 years
	I'll be grabbing my multi-meter from storage at the weekend ... Dans le forum Assembly and troubleshooting	il y a 2 years
	Time to dig out the multimeter, good idea and I'll let you k... Dans le forum Assembly and troubleshooting	il y a 2 years
	The good news is the LCD is not fried, I plugged it into ano... Dans le forum Assembly and troubleshooting	il y a 2 years
	I'll have a look at both of those tomorrow, I was earthed th... Dans le forum Assembly and troubleshooting	il y a 2 years
	Is it possible that the ribbon cables could be the source of... Dans le forum Assembly and troubleshooting	il y a 2 years
	Sadly I think this one is over a year old, worked perfectly ... Dans le forum Assembly and troubleshooting	il y a 2 years
	The light on the einsy turns on, the ribbon cables are inser... Dans le forum Assembly and troubleshooting	il y a 2 years
	Power not turning on... Dans le forum Assembly and troubleshooting	il y a 2 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

25 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé