david.b14 – Activité – Prusa3D Forum

Notifications

Clear all

david.b14

Groupe: Enregistré

A(ont) rejoint: 2016/10/31

Honorable Member

	I have not printed with Prusa PLA black yet, but I it readin... Dans le forum Others (Archive)	il y a 8 years
	If you run out of ideas, try printing on blue tape just as a... Dans le forum Others (Archive)	il y a 8 years
	Thanks for the info. I printed a spare extruder body with n... Dans le forum Others (Archive)	il y a 8 years
	Don't swith PSU switch from 110 to 220 while plugged in to t... Dans le forum Others (Archive)	il y a 8 years
	If you are really going to ditch the bad PSU, you could just... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Can you print the prusa logo from the SD card and post a pho... Dans le forum Others (Archive)	il y a 8 years
	Have you looked at the bed adjustment feature accessible fro... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	The fact that you have not printed anything on the new print... Dans le forum Others (Archive)	il y a 8 years
	Does extruder-body.stl need to be printed with supports? Dans le forum Others (Archive)	il y a 8 years
	No offense taken. Too much time on my hands for the holiday... Dans le forum Others (Archive)	il y a 8 years
	Simple way to stop print if pinda is hit, thermal run away t... Dans le forum Others (Archive)	il y a 8 years
	I think I fond an easier method that uses 3M Z-Axis tape (co... Dans le forum Others (Archive)	il y a 8 years
	I'm still waiting on the mk2 to arrive but I think will prin... Dans le forum Others (Archive)	il y a 8 years
	In the print settings there is a Notes area. A nice feature... Dans le forum Software (Archive)	il y a 8 years
	I really like what has been accomplished with the Prusa Slic... Dans le forum Software (Archive)	il y a 8 years
	Slic3r Prusa 1.31.6-prusa3d, loading 1.5 optimal profile? Dans le forum Software (Archive)	il y a 8 years
	In thinking about this more, the mesh level would be bypasse... Dans le forum Others (Archive)	il y a 8 years
	Get the eSun filament cleaner. I had a clog and did the ato... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	This thing works really well: Dans le forum Others (Archive)	il y a 8 years
	This article has some good information regarding material t... Dans le forum Others (Archive)	il y a 8 years

Page 23 / 30 Précédent Suivant

Statistiques du forum

565 Forums

63.4 K Sujets

445.3 K Messages

21 En-ligne

68.5 K Membres

Le dernier des messages: Xl extruder stops Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé