david.b14 – Activité – Prusa3D Forum

Notifications

Clear all

david.b14

Groupe: Enregistré

A(ont) rejoint: 2016/10/31

Honorable Member

	MatterControl Image to STL converter Dans le forum Print tips (Archive)	il y a 8 years
	Would it be okay to print the pinda probe protector in PETG? Dans le forum Others (Archive)	il y a 8 years
	Can you post a picture or the broken part. If the piece did... Dans le forum Others (Archive)	il y a 8 years
	Can you take the temp of the pinda probe? Sometimes it will... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Another nice solution featured in Hackaday: Dans le forum Others (Archive)	il y a 8 years
	Nice work. I think I will do the same, thanks for sharing. Dans le forum Others (Archive)	il y a 8 years
	5 tools for $10: EVINIS 5Pcs Stainless Steel Spatula Palett... Dans le forum Others (Archive)	il y a 8 years
	Also, does the defect you circled in red happen in only 1 co... Dans le forum Others (Archive)	il y a 8 years
	Working FDM 3D skateboard with strong filaments. Dans le forum Print tips (Archive)	il y a 8 years
	Another test you could do is hook up the MK2 LCD to an Ardui... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	With regard to the stepper motors and heat, it was something... Dans le forum Improvements (Archive)	il y a 8 years
	Thanks for the info, if possible please post a photo of your... Dans le forum Others (Archive)	il y a 8 years
	I would see if the problem is related to the PSU by doing th... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	The best thing is to have a parted printed as it sounds like... Dans le forum Others (Archive)	il y a 8 years
	Can you verify the led is blinking on the heater bed? Have ... Dans le forum Others (Archive)	il y a 8 years
	I have read that different colors of filament from the same ... Dans le forum Others (Archive)	il y a 8 years
	Just some data points for you to consider: -Different brand... Dans le forum Improvements (Archive)	il y a 8 years
	I would suggest using blue painter tape. Also, what is the ... Dans le forum Others (Archive)	il y a 8 years
	My best guess in looking at the 1st layer, it looks like the... Dans le forum Others (Archive)	il y a 8 years
	When you extrude filament does it go down or does it curl ba... Dans le forum Others (Archive)	il y a 8 years

Page 24 / 30 Précédent Suivant

Statistiques du forum

565 Forums

63.4 K Sujets

445.3 K Messages

22 En-ligne

68.5 K Membres

Le dernier des messages: PTFE tube Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé