DarthMuffin – Aktywność

Notifications

Clear all

DarthMuffin

Grupa: Zarejestrowany

Dołączył: 2017/05/04

Trusted Member

	Did you seat the screws on the right-hand side of the x axis... In forum Others (Archive)	8 years temu
	Clever way of keeping the light out of the way but yet close... In forum Improvements (Archive)	8 years temu
	Try this. Don't know if I have taken enough off, and it is ... In forum Improvements (Archive)	8 years temu
	I had a very similar problem. For me it turned out to be an... In forum Others (Archive)	8 years temu
	Neat idea! Wish I had thought of that when assembling. Eye... In forum Prusa i3 kit (Archive)	8 years temu
	I wasn't impressed with the bearings either, and ended up re... In forum Prusa i3 kit (Archive)	8 years temu
	I also had scratches and noise from a bearing after about a ... In forum Prusa i3 kit (Archive)	8 years temu
	I went with the relatively new Noctua 40x20mm fan for the he... In forum Improvements (Archive)	8 years temu
	john, care to share your ngen settings? I have some and wou... In forum Print tips (Archive)	9 years temu
	The new firmware hard codes the value to 161.3. It will rev... In forum Software (Archive)	9 years temu
	Intermittent Mintemp Bed errors, where to buy thermistor? In forum Others (Archive)	9 years temu

Strona 3 / 3 Wstecz

Statystyki Forum

595 Fora

70.4 K Tematy

493.1 K Posty

12 Online

81.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte