DarthMuffin – Aktivität

Benachrichtigungen

Alles löschen

DarthMuffin

Gruppe: Registriert

Beigetreten: 2017/05/04

Trusted Member

	Did you seat the screws on the right-hand side of the x axis... Im Forum Others (Archive)	Vor 8 years
	Clever way of keeping the light out of the way but yet close... Im Forum Improvements (Archive)	Vor 8 years
	Try this. Don't know if I have taken enough off, and it is ... Im Forum Improvements (Archive)	Vor 8 years
	I had a very similar problem. For me it turned out to be an... Im Forum Others (Archive)	Vor 8 years
	Neat idea! Wish I had thought of that when assembling. Eye... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I wasn't impressed with the bearings either, and ended up re... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I also had scratches and noise from a bearing after about a ... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I went with the relatively new Noctua 40x20mm fan for the he... Im Forum Improvements (Archive)	Vor 8 years
	john, care to share your ngen settings? I have some and wou... Im Forum Print tips (Archive)	Vor 9 years
	The new firmware hard codes the value to 161.3. It will rev... Im Forum Software (Archive)	Vor 9 years
	Intermittent Mintemp Bed errors, where to buy thermistor? Im Forum Others (Archive)	Vor 9 years

Seite 3 / 3 Vorherige

Forums-Statistiken

595 Foren

70.4 K Themen

493.1 K Beiträge

12 Online

81.9 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen