|
I just did some checking after hearing about 3.1.3. 3.1.2 is... In forum Buddy3D |
2 months ago |
|
Update from OP: I got the long 1/8" drill bit, put the nozzl... In forum Hardware, firmware and software help |
2 months ago |
|
Well, the 3.1.0 downgrade didn't do the trick. It worked fo... In forum Buddy3D |
4 months ago |
|
I just got finished with a support chat and they're sending ... In forum Buddy3D |
4 months ago |
|
Thanks for the tip. I ordered a 1/16" 6" drill bit (they see... In forum Hardware, firmware and software help |
5 months ago |
|
I like the hot air rework station idea. I can set that to a... In forum Hardware, firmware and software help |
5 months ago |
|
Diamondback nozzle clogged In forum Hardware, firmware and software help |
5 months ago |
|
A bit late for the OP but my advice is not to cut it close o... In forum General discussion, announcements and releases |
7 months ago |
|
I tried this and it made my gantry out of alignment, one sid... In forum General discussion, announcements and releases |
8 months ago |
|
Update: recalibrating filament sensor fixed it. I don't kno... In forum General discussion, announcements and releases |
8 months ago |
|
I upgraded to 6.3.4 and now can't load filament and as such ... In forum General discussion, announcements and releases |
8 months ago |
|
Yeah, same here. I ordered mine on day the core one DIY kit... In forum General discussion, announcements and releases |
10 months ago |
|
Does temperature calibration work for anyone else on 3.2.1? ... In forum Hardware, firmware and software help |
8 years ago |
|
Another +1 for the tensioner linked. It works great! In forum General discussion, announcements and releases |
8 years ago |
|
Have you looked to see if your Y bearing u-bolts hit the fra... In forum Hardware, firmware and software help |
8 years ago |
|
I still have three partial rolls of NGEN. I wasn't impresse... In forum General discussion, announcements and releases |
8 years ago |
|
I haven't tried these but looks like they may work if you're... In forum Others (Archive) |
8 years ago |
|
A follow-up...
Printer is nearly assembled, so far ABS is w... In forum Others (Archive) |
8 years ago |
|
Mk3 upgrade kit report In forum Others (Archive) |
8 years ago |
|
MK3 ordered together with MK2.5 or MK3 upgrades start shippi... In forum Others (Archive) |
8 years ago |
