|
I had a day 1 order and the smooth sheet + the satin sheet t... In forum General discussion, announcements and releases |
4 months ago |
|
1) I actually just printed a couple of fuzzy skin covered ob... In forum Hardware, firmware and software help |
4 months ago |
|
This is interesting. If true we would see something differe... In forum General discussion, announcements and releases |
4 months ago |
|
Compatibility and cost. No commentary on the prices Prusa c... In forum Hardware, firmware and software help |
4 months ago |
|
Yup. Keep in mind even the standard far end hits the stop ... In forum User mods |
4 months ago |
|
I was one of those who had a filter kit added to my 1/31 ord... In forum General discussion, announcements and releases |
4 months ago |
|
If you haven't already, be sure to try carefully unplugging ... In forum Hardware, firmware and software help |
4 months ago |
|
Yes, any sheet designed for a 256x256 Bambu should fit. It w... In forum User mods |
4 months ago |
|
Yeah the only thing I can think is that top priority was the... In forum User mods |
4 months ago |
|
Unlocking a little more build volume (with caveats) In forum User mods |
4 months ago |
|
There's a thread on the bambulab forums where users are runn... In forum Hardware, firmware and software help |
5 months ago |
|
According to support, my order is being held up because I re... In forum General discussion, announcements and releases |
5 months ago |
|
Ordered 6:22 GMT 1/31, still TBA. I wonder if the fact I re... In forum General discussion, announcements and releases |
5 months ago |
|
The way Prusa describes it seems reasonable though- high flo... In forum Hardware, firmware and software help |
5 months ago |
|
Clearly they left some items off of that changelog. The ful... In forum Hardware, firmware and software help |
5 months ago |
|
Is that with the latest firmware? So even with the filament... In forum Hardware, firmware and software help |
5 months ago |
|
Sounds like you're using the same Prusaslicer file that you ... In forum Hardware, firmware and software help |
5 months ago |
|
Did the meaning of "absorbing heat" change vs. the XL? I as... In forum Hardware, firmware and software help |
5 months ago |
|
I chose the left side because the printer does everything on... In forum User mods |
6 months ago |
|
I actually had a nozzle clean failure (after 6.3.1) on some ... In forum Hardware, firmware and software help |
6 months ago |
