Notifications
Clear all
Daniel10712
Grupa: Zarejestrowany
Dołączył: 2020/12/09
Active Member
1
| In an earlier comment I said the x-axis doesn't run complete... | 4 years temu | |
| No worries, I was going to use the oil provided with the pri... | 4 years temu | |
| Thanks for the reply 😃. Do I have to use the grease provided... | 4 years temu | |
| I think I have found out what causes the problem. The x axis... | 4 years temu | |
| RE: Problems with printing circles | 4 years temu | |
| Problems with printing circles | 4 years temu | |
| The problem is solved. The trapezoid nuts were accidentally ... | 4 years temu | |
| Here is a picture of the position in which the extruder star... | 4 years temu | |
| Calibration XYZ home problem MK3S | 4 years temu |