Notifications
Clear all
Daniel10712
Skupina: Registrovaný
Přidal se: 2020/12/09
Active Member
1
| In an earlier comment I said the x-axis doesn't run complete... | před 5 years | |
| No worries, I was going to use the oil provided with the pri... | před 5 years | |
| Thanks for the reply 😃. Do I have to use the grease provided... | před 5 years | |
| I think I have found out what causes the problem. The x axis... | před 5 years | |
| RE: Problems with printing circles | před 5 years | |
| Problems with printing circles | před 5 years | |
| The problem is solved. The trapezoid nuts were accidentally ... | před 5 years | |
| Here is a picture of the position in which the extruder star... | před 5 years | |
| Calibration XYZ home problem MK3S | před 5 years |