Notifications
Clear all
daniel.o10
daniel.o10
Group: Registered
Joined: 2017/12/19
Active Member
1
I have run out of things to try for XYZ calibration failure

In forum Hardware, firmware and software help

5 years ago
Tim--apologies for media. I've included the photos here per ...

In forum Assembly and first prints troubleshooting

5 years ago
Thanks Tim!Here are two more images of just the first layer:...

In forum Assembly and first prints troubleshooting

5 years ago
Any idea why prints are turning out like this?

In forum Assembly and first prints troubleshooting

5 years ago
It's probably worth adding that as far as I can tell, nothin...

In forum Hardware, firmware and software help

5 years ago
Broken PINDA probe, but no replacement

In forum Hardware, firmware and software help

5 years ago
UPDATE: So after troubleshooting everything I could possibly...

In forum Hardware, firmware and software help

6 years ago
UPDATE: So after troubleshooting everything I could possibly...

In forum Hardware, firmware and software help

6 years ago
Filament loads fine, then first print fails, filament wispy?

In forum Hardware, firmware and software help

6 years ago
Filament stops loading mid-print

In forum Hardware, firmware and software help

6 years ago
How to replace cartridge heater?

In forum Hardware, firmware and software help

7 years ago
Printer making 'clicking noise' no filament coming out of ex...

In forum Others (Archive)

7 years ago
Why are prints turning out like this?

In forum Others (Archive)

7 years ago
Thermistor fail after smoke/melted plastic smell emitted fro...

In forum Others (Archive)

7 years ago
Share: