Activity
 
Notifications
Clear all
Daniel
Daniel
Group: Registered
Joined: 2021/08/28
Active Member
1
If this happens again, it may be the heatbreak is not pushed...

In forum General discussion, announcements and releases

3 years ago
My thought for the garage was just using something like the ...

In forum General discussion, announcements and releases

3 years ago
Printing Environment

In forum General discussion, announcements and releases

3 years ago
That was it, thank you!

In forum Hardware, firmware and software help

3 years ago
Update: I've narrowed it down to the far side of the bed so ...

In forum Hardware, firmware and software help

3 years ago
Reassembled hotend and now fan is acting up

In forum Hardware, firmware and software help

3 years ago
An update. I printed again with properly dried PLA and some ...

In forum How do I print this? (Printing help)

3 years ago
That is an idea I will definitely keep in mind. The print do...

In forum How do I print this? (Printing help)

3 years ago
I'd love to not have to widen them too much, but I will if a...

In forum How do I print this? (Printing help)

3 years ago
Yes, after I posted, I went and read a few other posts here ...

In forum How do I print this? (Printing help)

3 years ago
First Custom Print (PETG)

In forum How do I print this? (Printing help)

3 years ago
Well, yeah, it looks ok. But I ended up changing the offset ...

In forum Assembly and first prints troubleshooting

3 years ago
This is using -0.005 offset. I've done this step a few times...

In forum Assembly and first prints troubleshooting

3 years ago
First Prints With Stringy Edges / Messy First Layers

In forum Assembly and first prints troubleshooting

3 years ago
Share: