Prusa3D Forum

Notifications

Clear all

DadOf6

Groupe: Enregistré

A(ont) rejoint: 2020/11/29

Active Member

	Same - I've been running 3.12.2 for a while without issue. ... Dans le forum Hardware, firmware and software help	il y a 2 years
	From/p> All five red and green LEDs blinking The MMu2S unit ... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Haha right after I posted this I found I could remove the ma... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Change color at layer Dans le forum How do I print this? (Printing help)	il y a 3 years
	I realize this thread has been dormant for some time but tho... Dans le forum General discussion, announcements and releases	il y a 4 years
	Thanks @bobstro & @dan-rogers! Yes, I was being too del... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@bobstro Thanks - yes I did try that as well - a few times. ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Hmm I am not sure why all of my details did not end up in th... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Weird pulling / waves on first layer Dans le forum How do I print this? (Printing help)	il y a 4 years
	@lize Thank you! I've done some playing with that and actua... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@dan-rogers Thanks Dan - I don't have Ironing enabled, and I... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@andy-w-2 You do get a lot more familiar with the workings d... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Nozzle hitting at the end of the print? Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Yes I got the same thing when I printed the vase the other d... Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

20 En-ligne

68.1 K Membres

Le dernier des messages: Why is the startup so bloody slow?!? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé