Čeština
Fóra
Uživatelé
DadOf6
Aktivita
 
Notifications
Clear all
DadOf6
DadOf6
Skupina: Registrovaný
Přidal se: 2020/11/29
Active Member
1
Profile Aktivita
Same - I've been running 3.12.2 for a while without issue. ...

In forum Hardware, firmware and software help

 před 2 years
From/p> All five red and green LEDs blinking The MMu2S unit ...

In forum Assembly and first prints troubleshooting

 před 2 years
Haha right after I posted this I found I could remove the ma...

In forum How do I print this? (Printing help)

 před 3 years
Change color at layer

In forum How do I print this? (Printing help)

 před 3 years
I realize this thread has been dormant for some time but tho...

In forum General discussion, announcements and releases

 před 4 years
Thanks @bobstro & @dan-rogers! Yes, I was being too del...

In forum How do I print this? (Printing help)

 před 4 years
@bobstro Thanks - yes I did try that as well - a few times. ...

In forum How do I print this? (Printing help)

 před 4 years
Hmm I am not sure why all of my details did not end up in th...

In forum How do I print this? (Printing help)

 před 4 years
Weird pulling / waves on first layer

In forum How do I print this? (Printing help)

 před 4 years
@lize Thank you! I've done some playing with that and actua...

In forum Assembly and first prints troubleshooting

 před 4 years
@dan-rogers Thanks Dan - I don't have Ironing enabled, and I...

In forum Assembly and first prints troubleshooting

 před 4 years
@andy-w-2 You do get a lot more familiar with the workings d...

In forum Assembly and first prints troubleshooting

 před 4 years
Nozzle hitting at the end of the print?

In forum Assembly and first prints troubleshooting

 před 4 years
Yes I got the same thing when I printed the vase the other d...

In forum Assembly and first prints troubleshooting

 před 4 years
Share: