Polski
Fora
Członkowie
DadOf6
Aktywność
 
Notifications
Clear all
DadOf6
DadOf6
Grupa: Zarejestrowany
Dołączył: 2020/11/29
Active Member
1
Profil Aktywność
Same - I've been running 3.12.2 for a while without issue. ...

In forum Hardware, firmware and software help

 2 years temu
From/p> All five red and green LEDs blinking The MMu2S unit ...

In forum Assembly and first prints troubleshooting

 3 years temu
Haha right after I posted this I found I could remove the ma...

In forum How do I print this? (Printing help)

 4 years temu
Change color at layer

In forum How do I print this? (Printing help)

 4 years temu
I realize this thread has been dormant for some time but tho...

In forum General discussion, announcements and releases

 5 years temu
Thanks @bobstro & @dan-rogers! Yes, I was being too del...

In forum How do I print this? (Printing help)

 5 years temu
@bobstro Thanks - yes I did try that as well - a few times. ...

In forum How do I print this? (Printing help)

 5 years temu
Hmm I am not sure why all of my details did not end up in th...

In forum How do I print this? (Printing help)

 5 years temu
Weird pulling / waves on first layer

In forum How do I print this? (Printing help)

 5 years temu
@lize Thank you! I've done some playing with that and actua...

In forum Assembly and first prints troubleshooting

 5 years temu
@dan-rogers Thanks Dan - I don't have Ironing enabled, and I...

In forum Assembly and first prints troubleshooting

 5 years temu
@andy-w-2 You do get a lot more familiar with the workings d...

In forum Assembly and first prints troubleshooting

 5 years temu
Nozzle hitting at the end of the print?

In forum Assembly and first prints troubleshooting

 5 years temu
Yes I got the same thing when I printed the vase the other d...

In forum Assembly and first prints troubleshooting

 5 years temu
Share: