Prusa3D Forum

Notifications

Clear all

Cybergurke

Grupa: Zarejestrowany

Dołączył: 2022/12/10

Active Member

	The first alpha has just been released, I installed it strai... In forum Hardware, firmware and software help	2 years temu
	Did the tests from the video with the new firmware and slice... In forum Assembly and first prints troubleshooting	2 years temu
	After my first short test, the printer has become a lot quie... In forum Assembly and first prints troubleshooting	2 years temu
	I use the default Gcode and my printer does park after print... In forum Hardware, firmware and software help	2 years temu
	I send this Video to Prusa/p> They said that these are norma... In forum Assembly and first prints troubleshooting	2 years temu
	Have observed the same thing with my dualhead. In forum Assembly and first prints troubleshooting	2 years temu
	I have tested it, only after the number of layers set at fad... In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

585 Fora

68.3 K Tematy

478.1 K Posty

13 Online

76 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte