Prusa3D Forum

Notifications

Clear all

Cybergurke

Skupina: Registrovaný

Přidal se: 2022/12/10

Active Member

	The first alpha has just been released, I installed it strai... In forum Hardware, firmware and software help	před 1 year
	Did the tests from the video with the new firmware and slice... In forum Assembly and first prints troubleshooting	před 1 year
	After my first short test, the printer has become a lot quie... In forum Assembly and first prints troubleshooting	před 1 year
	I use the default Gcode and my printer does park after print... In forum Hardware, firmware and software help	před 2 years
	I send this Video to Prusa/p> They said that these are norma... In forum Assembly and first prints troubleshooting	před 2 years
	Have observed the same thing with my dualhead. In forum Assembly and first prints troubleshooting	před 2 years
	I have tested it, only after the number of layers set at fad... In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

579 Fóra

65.4 K Témata

457.6 K Příspěvky

38 Online

72.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed