Notifications
Clear all
cwbullet
cwbullet
Skupina: PrusaLink-beta
Přidal se: 2018/07/13
Název: Member
These items are for a product and may be sold. I cannot sel...

In forum General discussion, announcements and releases

před 4 years
I have been using this for over a month and also really like...

In forum General discussion, announcements and releases

před 4 years
I would prefer not gluing. That creates unsightly seams. I...

In forum General discussion, announcements and releases

před 4 years
I will try that next. I have tried 0, 45, and 90 degrees ro...

In forum General discussion, announcements and releases

před 4 years
What are your specific questions? It works. I have about 3...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 4 years
Question: is this how PCBs are made normally?

In forum General discussion, announcements and releases

před 4 years
The simple answer Is yes. We have plenty of UK users.

In forum General discussion, announcements and releases

před 4 years
Where is that (Thick Bridges) set? I do not see that as a s...

In forum PrusaSlicer

před 4 years
I am pretty sure that has been discontinued. I would contac...

In forum General discussion, announcements and releases

před 4 years
I will check, but I did not turn it on.

In forum PrusaSlicer

před 4 years
I did some test prints last night and printed it with the bu...

In forum General discussion, announcements and releases

před 4 years
I forgot to inset the file. I was in rush to get to work. ...

In forum General discussion, announcements and releases

před 4 years
I could upload one but I am using standard settings with no ...

In forum General discussion, announcements and releases

před 4 years
Good news. I wonder if they have changed something

In forum Hardware, firmware and software help

před 4 years
Duramic Silver PETG is a good filament. It is not the only ...

In forum How do I print this? (Printing help)

před 4 years
Advice wanted - Supports

In forum General discussion, announcements and releases

před 4 years
Is that a 3D Jake made filament or by another manufacturer?

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 4 years
Prusament. I am using a 0.4mm nozzle and stand Prusament se...

In forum How do I print this? (Printing help)

před 4 years
This might help:

In forum PrusaSlicer

před 4 years
I was able to get it to print last night. It printed ok for...

In forum How do I print this? (Printing help)

před 4 years
Stránka 129 / 571
Share: