CorpseGuard – Aktivita – Prusa3D Forum

Notifications

Clear all

CorpseGuard

Skupina: Registrovaný

Přidal se: 2017/02/13

Trusted Member

	The print wasn't hard to remove. It was a tiger tank which h... In forum Prusa i3 kit (Archive)	před 8 years
	When I got that with my first big print I was a bit upset to... In forum Prusa i3 kit (Archive)	před 8 years
	Problem with printbed after my 5 print 🙁 In forum Prusa i3 kit (Archive)	před 8 years
	Printing issue In forum Prusa i3 kit (Archive)	před 8 years
	I dont know what the problem is but after pressing reset it ... In forum Others (Archive)	před 8 years
	Recalibrate doesn't fix the problem. I tried it often. But t... In forum Prusa i3 kit (Archive)	před 8 years
	Always at point 4? And after pressing reset it was over? And... In forum Prusa i3 kit (Archive)	před 8 years
	And after press reset it's all ok? I don't think so. The noo... In forum Prusa i3 kit (Archive)	před 8 years
	So here we go. Please take a look at this. I make a video o... In forum Prusa i3 kit (Archive)	před 8 years
	So guys. Please take a look at this. I don't think that'... In forum Others (Archive)	před 8 years
	Hello there. I have the same problem. At point 4/9 my noozle... In forum Others (Archive)	před 8 years
	There was no problem with the z axis. It moves in the bed ev... In forum Prusa i3 kit (Archive)	před 8 years
	Problem at the first start on every print. In forum Prusa i3 kit (Archive)	před 8 years

Stránka 4 / 4 Předchozí

Fórum Statistiky

565 Fóra

64.5 K Témata

451.9 K Příspěvky

23 Online

71.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed