Italiano
Forum
Utenti
coolRR
Attività
 
Notifiche
Cancella tutti
coolRR
coolRR
Gruppo: Registrato
Registrato: 2017/04/09
Trusted Member
3
Profilo Attività
I found the problem! I did a self-test and the Y stopper was...

Nel forum Others (Archive)

 7 years fa
I did another experiment now. I disconnected the belt from t...

Nel forum Others (Archive)

 7 years fa
Belt tight? Teeth on belt ok? If the motor is moving and t...

Nel forum Others (Archive)

 7 years fa
It sounds like the locking grub screw on the pulley that att...

Nel forum Others (Archive)

 7 years fa
I'll add another point of information in case it's helpful: ...

Nel forum Others (Archive)

 7 years fa
Troubleshooting Y axis

Nel forum Others (Archive)

 7 years fa
Problems using M600 / multicolor prints

Nel forum Others (Archive)

 7 years fa
Buying a replacement heatbed

Nel forum Others (Archive)

 7 years fa
Thank you Walter! I'll check it out.

Nel forum Others (Archive)

 7 years fa
Thanks for your input guys! I was wondering if you had don...

Nel forum Others (Archive)

 7 years fa
Mildew on PLA printed parts?

Nel forum Others (Archive)

 7 years fa
Why are my supports being messed up?

Nel forum Others (Archive)

 7 years fa
Thanks for your advice guys!

Nel forum Prusa i3 kit (Archive)

 7 years fa
Can a failed print damage the printer?

Nel forum Prusa i3 kit (Archive)

 7 years fa
Thanks Peter.

Nel forum Prusa i3 kit (Archive)

 7 years fa
Thanks Peter. I did auto-home now, but it moves all the axes...

Nel forum Prusa i3 kit (Archive)

 7 years fa
Moving axes without grinding

Nel forum Prusa i3 kit (Archive)

 7 years fa
Why is the Simplify3D Prusa profile not working?

Nel forum Others (Archive)

 7 years fa
Hi everyone, I've used "Original Prusa i3 MK2 RC4.fff" toda...

Nel forum General discussion, announcements and releases

 7 years fa
Thank you Petra! I'll check out that post.

Nel forum Prusa i3 kit (Archive)

 7 years fa
Pagina 2 / 3
Condividi: