Notifications
Clear all
Constructicon
Skupina: Registrovaný
Přidal se: 2023/01/01
Active Member
1
|
Nevermind, the setting was hidden behind the "Expert" mode f... In forum PrusaSlicer |
před 3 years | |
|
I was in the right version, the issue was that I wasn't in "... In forum PrusaSlicer |
před 3 years | |
|
I'm having trouble finding the "Avoid crossing curled overha... In forum PrusaSlicer |
před 3 years | |
|
Nice!I am trying to set up a test for organic supports with ... In forum PrusaSlicer |
před 3 years | |
| I found that I had to not tighten any of the screws down all... | před 3 years | |
| PSA How to Fix "Calibration failed, check axes and run again... | před 3 years | |
| Thanks, this did it. I loosened the two z motors, the z top ... | před 3 years | |
| Thanks for the clarification. I think that's the problem. Wh... | před 3 years | |
| I was able to get through calibration by loosening the trape... | před 3 years | |
| I'm running into this exact same problem. Self test works fi... | před 3 years |