Prusa3D Forum

Notifications

Clear all

clemens.m3

Grupa: Zarejestrowany

Dołączył: 2018/06/26

Active Member

	Thanks! I will play some more with the first layer cal and p... In forum Hardware, firmware and software help	5 years temu
	@bobstro Do you think the thickness of my first layer has an... In forum Hardware, firmware and software help	5 years temu
	Sorry it took so long, i did a litte vacation in the meantim... In forum Hardware, firmware and software help	5 years temu
	Uneven Prindbed 0.6mm difference in one Corner In forum Hardware, firmware and software help	5 years temu
	Mine was ordered 21/6, sheet says it has shipped. It hasn't.... In forum General discussion, announcements and releases	6 years temu
	Mine was ordered 21/6, sheet says it has shipped. It hasn't.... In forum General discussion, announcements and releases	6 years temu

Statystyki Forum

565 Fora

63.9 K Tematy

447.7 K Posty

23 Online

69.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte