Prusa3D Forum

Notifiche

Cancella tutti

clemens.m3

Gruppo: Registrato

Registrato: 2018/06/26

Active Member

	Thanks! I will play some more with the first layer cal and p... Nel forum Hardware, firmware and software help	5 years fa
	@bobstro Do you think the thickness of my first layer has an... Nel forum Hardware, firmware and software help	5 years fa
	Sorry it took so long, i did a litte vacation in the meantim... Nel forum Hardware, firmware and software help	5 years fa
	Uneven Prindbed 0.6mm difference in one Corner Nel forum Hardware, firmware and software help	5 years fa
	Mine was ordered 21/6, sheet says it has shipped. It hasn't.... Nel forum General discussion, announcements and releases	6 years fa
	Mine was ordered 21/6, sheet says it has shipped. It hasn't.... Nel forum General discussion, announcements and releases	6 years fa

Statistiche Forum

565 Forum

63.9 K Discussioni

447.7 K Post

21 Online

69.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso