Čeština
Fóra
Uživatelé
Clemens M.
Aktivita
 
Notifications
Clear all
Clemens M.
Clemens M.
Skupina: Registrovaný
Přidal se: 2017/08/29
Noble Member
3
Profile Aktivita
YES - here is my wish: Please send your printer to me - you ...

In forum General discussion, announcements and releases

 před 5 years
No - the board is completely different - it is a new 32-bit ...

In forum General discussion, announcements and releases

 před 5 years
Is there furthere information available - would like to unde...

In forum How do I print this? (Printing help)

 před 5 years
What would it tell us if they are about 2,0 or 1,5 mm - can ...

In forum How do I print this? (Printing help)

 před 5 years
Which firmware version do you use? I had same problem on a M...

In forum How do I print this? (Printing help)

 před 5 years
Hallo, 2 years ago I thought about bying a 3D-printer. So I ...

In forum General discussion, announcements and releases

 před 5 years
And an other question (I couldn't Edit my Post, because it i...

In forum General discussion, announcements and releases

 před 5 years
Hallo, I don think that this is an issue on bearings, rods...

In forum General discussion, announcements and releases

 před 5 years
The same way I do - it´s a work arround and could be solved ...

In forum PrusaSlicer

 před 5 years
So we will get this functionality - it´s just a question of ...

In forum PrusaSlicer

 před 5 years
Brim only for some objects on the build plate

In forum PrusaSlicer

 před 5 years
The appearance of the RaspberryPi 4 with 4GB RAM was the rea...

In forum General discussion, announcements and releases

 před 6 years
Installation of PrusaSlicer 2.0 on a RaspberryPi

In forum General discussion, announcements and releases

 před 6 years
Stránka 82 / 82
Share: