Notifications
Clear all
christophe.p
christophe.p
Grupa: Moderator
Dołączył: 2016/02/14
Tytuł: Member Moderator
1
Hi, just made a test based on what is discussed there, usin...

In forum Others (Archive)

8 years temu
@Peter, You don't have to feel sorry ^^ However since it sh...

In forum Software (Archive)

8 years temu
Adding skip detection during firmware self-test

In forum Software (Archive)

8 years temu
@Nigel: Yes I agree but since OP tell that he wants to let t...

In forum Others (Archive)

8 years temu
In your case, a printing enclosure may help to prevent issue...

In forum Others (Archive)

8 years temu
Hi Janis, I just printed your gcode with no issue on the to...

In forum Prusa i3 kit (Archive)

8 years temu
Hi Peter, Yes I have the 1.7.3 package, and I do not use US...

In forum Others (Archive)

8 years temu
I'm a bit confused. I tried multiple times to go to 3.0.5 R...

In forum Others (Archive)

8 years temu
Ok Peter, I understand better now, I was sure it was not all...

In forum Improvements (Archive)

8 years temu
Just realised that the graph are in wrong order. Sorry for ...

In forum Improvements (Archive)

8 years temu
Ok, a quick update: Rebooting my computer fix my write den...

In forum Others (Archive)

8 years temu
Hi, back from travel I wanted to give a go to this Firmware,...

In forum Others (Archive)

8 years temu
HI Andreas, I used a 55 × 55 cm (10 mm width) cork tile and...

In forum Others (Archive)

8 years temu
I was as surprised as you ^^ It was on a stl exported from ...

In forum Software (Archive)

8 years temu
Hi Prusayo, For the record, the application that gave me th...

In forum Software (Archive)

8 years temu
Hi Shree Something like that should be a better solution:

In forum Others (Archive)

8 years temu
Hi Peter, That's a clever deduction. Then the very first st...

In forum Others (Archive)

8 years temu
I made some measurement before and after using Octoprint. S...

In forum Improvements (Archive)

8 years temu
MK2 HeatBed insulation

In forum Improvements (Archive)

8 years temu
Since I'm using mostly 110 °C as first layer temperature for...

In forum Others (Archive)

8 years temu
Strona 18 / 29
Share: