Prusa3D Forum

Notifications

Clear all

chrischin

Groupe: Enregistré

A(ont) rejoint: 2018/12/15

Trusted Member

	Turns out I was putting the second temperature commands afte... Dans le forum PrusaSlicer	il y a 5 months
	Start G-code Omitted from Sliced G-code 2.8.0 Dans le forum PrusaSlicer	il y a 6 months
	Thanks so much for the recommended settings and detailed exp... Dans le forum PrusaSlicer	il y a 11 months
	Interesting. I've read through several of these posts but ju... Dans le forum PrusaSlicer	il y a 11 months
	If I print with no infill the gap issue is mostly gone (thir... Dans le forum PrusaSlicer	il y a 11 months
	Extrusion gap near seam/deretraction Dans le forum PrusaSlicer	il y a 11 months
	Actually, I tried this again and it does fix it. I was getti... Dans le forum PrusaSlicer	il y a 1 year
	Ah, I see what you're saying about the infill, but one thing... Dans le forum PrusaSlicer	il y a 1 year
	Thanks. But why wouldn't the gap exist at the outer edge, un... Dans le forum PrusaSlicer	il y a 1 year
	Overhang Gap Dans le forum PrusaSlicer	il y a 1 year
	Confirmed, Prusa docs say this about the thin walls setting:... Dans le forum PrusaSlicer	il y a 2 years
	But the seam looks as smooth as can be on the Classic settin... Dans le forum PrusaSlicer	il y a 2 years
	Print just finished with 0.6mm nozzle QUALITY profile and al... Dans le forum PrusaSlicer	il y a 2 years
	Thanks. I did also notice some z artifacts on my print, whic... Dans le forum PrusaSlicer	il y a 2 years
	How could Arachne possibly be the default when it's so unrel... Dans le forum PrusaSlicer	il y a 2 years
	Attached zipped PrusaSlicer Project file Box-Arachne... Dans le forum PrusaSlicer	il y a 2 years
	Seams Issue with Arachne Dans le forum PrusaSlicer	il y a 2 years
	@edg-engineering-2 I think I just accepted these gaps and di... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@chocki Nice! Have you considered a volcano hot end upgrade?... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@bobstro In the before gcode I turned down the "M221 S95" co... Dans le forum How do I print this? (Printing help)	il y a 5 years

Page 1 / 3 Suivant

Statistiques du forum

567 Forums

64.7 K Sujets

453.3 K Messages

20 En-ligne

71.6 K Membres

Le dernier des messages: Opening .stl file Notre nouveau membre: Sedacrivity Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé